Revised ASTM Standard Expands Limit on Biofuel Contamination in Jet Fuels

A new revision to ASTM International’s Aviation Turbine Fuel Standard (ASTM D1655) safely adapts to the growing global presence of biodiesel in the petroleum industry.

ASTM D1655 has been used for decades by the aviation community to help ensure quality control and safe distribution of jet fuel. Biodiesel blends – which have a small percentage of fatty acid methyl esters (FAME) – increasingly use the same distribution systems (e.g., shipping containers, pipelines, etc.) as jet fuel. After biodiesel is transported through a distribution system, there is a possibility that traces of FAME may be picked up by jet fuel, which later uses that same distribution system.  

The initial response to the introduction of biodiesels into the marketplace was to maintain an undetectable level of FAME contamination in jet fuel. Due to the costs associated with that requirement and the rising presence of biofuels worldwide, industry experts studied whether the level of allowable FAME in jet fuel could be increased without compromising safety nor adversely affecting aircraft operation. As a result, the revised standard safely increases the allowable cross-contamination of FAME in jet fuel from 5.0 parts per million to 50 parts per million.  

“The jet fuel specification keeps the aviation industry safe while adapting to the expanded presence of biofuels,” says ASTM member David J. Abdallah, Exxon Mobil Research and Engineering. “In fact, no discernible negative impact on jet fuel product quality was observed with up to 400 ppm of biodiesel.”  Abdallah noted that a potential future revision could further increase the standard to allow 100 parts per million.

ASTM D1655 was developed by ASTM Subcommittee D02.J0 on Aviation Fuels and D02.J0.01 on Jet Fuel Specifications, part of Committee D02 on Petroleum Products, Liquid Fuels and Lubricants. 

The body of evidence used to support this revision included EI-JIP Report, Joint Industry Project: Seeking original equipment manufacturer (OEM) approvals for 100 mg/kg fatty acid methyl ester (FAME) in aviation turbine fuel. The study demonstrated that increasing the allowable levels of FAME in jet fuel would not compromise aircraft safety nor adversely affect aircraft operation.  

To purchase ASTM International standards, visit www.astm.org and search by the standard designation, or contact ASTM Customer Relations (tel +1.877.909.ASTM; [email protected]). ASTM welcomes participation in the development of its standards. Become a member at www.astm.org/JOIN.