Stand alone gas detector

Gas detector

Stand alone gas detector

12 Nov, 2009

Published over 17 years ago. See the latest and most current information on Gas detector.

The Gas Point from Recom (Italy) is an economical, microprocessor-based gas detector for continuous monitoring of toxic gases, oxygen or inflammable gases. Non intrusive calibration and maintenance is performed using a magnetic wand to access the software through the enclosure window – no need to open the enclosure (and obtain special area permits) to perform routine calibrations.

The backlight LCD graphic display shows the gas reading, with wide and visible numbers, together with the measure unit and the gas name.

In the programming mode it is possible to change the gain, the off-set, two alarm thresholds, the average, the full scale value, the sensor fail event. So, it is possible to use the same control unit with all catalytic, galvanic or electrochemical sensors. High sensitivity, long term stability and no false alarms are the hallmark of the new and improved sensors. Fastest response to the target gas combined with minimal interference buy other gases or environmental influences as well as the sensor life-time determine the reliability and the operating cost of a system. Moreover, Gas Point has an analog 4-20 mA output, for remote control or to transmit the alarm signal. Integrated control on the power supply assures the correct work also in the case of unstable voltages.

Latest News

PIN 27.5 Oct/Nov 26

Explore our Digital Edition

Discover the latest news and research

Digital edition

Explore Our Other Sites

Labmate Online
Precision, elegance and innovation for modern laboratories
Explore more Arrow
Envirotech Online
Vehicle-based methane detection system passes German suitability test
Explore more Arrow
Pollution Solutions Online
Large-scale liquefied biogas bunkering to become possible in the Port of Gothenburg in 2027
Explore more Arrow
Chromatography Today
High-load peptide purification
Explore more Arrow