Flow Level Pressure
Process Ready Ultrasonic Flowmeter
Sep 13 2017 Read 654 Times
Designed to IP65 standards the Process Atrato ultrasonic flowmeter from Titan Enterprises is built for use in demanding process and control environments.
Durably constructed from 316 stainless steel and PEEK, and incorporating proprietary ultrasonic flowmeter technology, the Process Atrato offers reduced cost of ownership compared to existing flow measurement devices used in the process environment.
Rated for use up to 65°C and 20Bar the compact Process Atrato is available in 4 models operating over flow ranges from 2ml/min to 15litres/min, featuring an accuracy of ±1% over the whole flow range. Each Process Atrato is calibrated with a pre-set 'K' factor so all meters of the same flow range are fully interchangeable simplifying assembly and set-up procedures for OEM manufacturers looking to integrate the flowmeter into their process and control set-up.
Using patented technology that enables it to operate accurately over wide flow ranges, the Process Atrato signal processing system permits flow measurement across the whole Reynolds number range allowing both viscous and non-viscous products to be metered.
Do you like or dislike what you have read? Why not post a comment to tell others / the manufacturer and our Editor what you think. To leave comments please complete the form below. Providing the content is approved, your comment will be on screen in less than 24 hours. Leaving comments on product information and articles can assist with future editorial and article content. Post questions, thoughts or simply whether you like the content.
In This Edition... Fuel for Thought - A good year for Endress+Hauser - Dr. Shah honoured by Society of Tribologists and Lubrication Engineers - DURAG Group acquire AP2E Analytical Instru...
View all digital editions
Jul 30 2018 Moon Township, PA, USA
Aug 06 2018 Westminster, CO, USA
Aug 09 2018 Madrid, Spain
Aug 27 2018 Stavanger, Norway
Sep 03 2018 Abu Dhabi, UAE